Welding Forum Community presented by LONGEVITY
Results 1 to 3 of 3

Thread: Cutmaster 81 issue

  1. #1

    Cutmaster 81 issue

    Iím not sure if this is where I should be in this section but here we go. I have a thermal dynamics cutmaster 81. It has never had a problem. Today I turned it on, but no air or arc was coming from the torch. I restarted the machine and now it will not power on. The switch is good and Iím getting power to the contactor but nothing out of it. What do I do?!?

  2. #2
    Senior Member
    Join Date
    Dec 2010
    Andover, Ohio
    Welcome to the forum, Bryan.
    Did you try going to thermal dynamics?

  3. #3
    They basically told me to buy a new one.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts