PDA
View Full Version :

Cutmaster 81 issue



Bryan
03-20-2018, 11:49 PM
Iím not sure if this is where I should be in this section but here we go. I have a thermal dynamics cutmaster 81. It has never had a problem. Today I turned it on, but no air or arc was coming from the torch. I restarted the machine and now it will not power on. The switch is good and Iím getting power to the contactor but nothing out of it. What do I do?!?

M J Mauer
03-22-2018, 04:16 AM
Welcome to the forum, Bryan.
Did you try going to thermal dynamics?

Bryan
03-23-2018, 01:54 AM
They basically told me to buy a new one.