PDA
View Full Version :

200p plasma specs



vault
03-15-2009, 11:10 AM
Simon,
I think the LS 200p Plasma specs on your site are actually the 160P's here is a copy and paste from the longevity site of the ls 200P plasma description read the paragraph portion compared to the thicknesses listed I bolded the portion that is inconsistant.

3" Per minute @ 1.0" Steel (Severance Cut)
7" Per minute @ 3/4" Thick Steel
17" Per minute @ 1/2" Thick Steel

* 50 Amp Plasma cutter: Duty Cycle 60% at 50 Amp and 100% at 30 Amps. 0.5 inches clean cut with 7.2 inches per minutes; 3/4 inches severance cut with 3.1 inches per minute. Rated Output Current is 40Amps under both AC 110V and 220V. Works in both 50 and 60 Hz with operating air pressure as 65 psi @ 3 cfm.

It looks like that portion is the 160p's specs

3" Per minute @ 3/4" Steel (Severance Cut)
7" Per minute @ 1/2" Thick Steel
17" Per minute @ 3/8" Thick Steel

* 40 Amps Plasma cutter: Duty Cycle 60% at 40 Amps and 100% at 30 Amps. 0.5 inches clean cut with 7.2 inches per minutes; 3/4 inches severance cut with 3.1 inches per minute. Rated Output Current is 40Amps under both AC 110V and 220V. Works in both 50 and 60 Hz with operating air pressure as 65 psi @ 3 cfm.