PDA
View Full Version :

SheetCam cutting rules info



acourtjester
02-28-2014, 08:51 AM
I found a video about SheetCam that may be of interest to others I am going to start using the info. This shows how you can improve the cutting path by changing the speed of the torch during a cutting operation. The is only when using SheetCam development version and I do not know if you can only use it if you have bought sheetcam. One thing I did find is when using the rules after you have created them do not have it selected in both locations show in the images attached here either work but not both at the same time.
Here is the video https://www.youtube.com/watch?v=_gsNhcWF2lE
another video about the same https://www.youtube.com/watch?v=hC_TRbmlzpE

Have fun
Tom
:joker

Gadget
02-28-2014, 10:52 AM
You can have TNG and Development installed on the same computer, they load into different folders. I've been running them both on the same unit for years.