PDA
View Full Version :

finally getting a lil time



zx12ryder
01-19-2014, 06:25 PM
As of late i have been getting a lil more time to mess around with my longevity 160PI. I have some 6010 rods i would like to practice on some scrap metal with just need to make sure i get the right metal. I.D.'ing metal that i come across is something i must be able to do so as to get and use the correct rods. Telling the diff between aluminum and mild steel is easy but what about the types of steel that may contain more carbon than others? Am i over analyzing this? Any advice would be greatly appreciated.