PDA
View Full Version :

Force cut 80i fixed.



THECNCMAN
07-23-2011, 09:36 AM
hello guys. After check the transformers and all the relays. I find the problem.
1) look the pictures. I can't believe how the contact holder of the start points coils get out.
When i put back in position is hard and tie. That goes on the top of the black plastic p[iece.
2) after that i put the board back in position and i tried to run the machine but i don't get arc. Why?
The gap of the points were about 1/8 o more.
I closed about a 1/32.
I running the machine again and i get the pilot arc nice.

Thanks guys for tried to help me
now simon: Hard to fiend the problem.32223223

Gadget
07-23-2011, 12:09 PM
Glad you got it working.

LONGEVITY
07-23-2011, 01:21 PM
Carlos,

Great Job! Glad you got it working as I checked the test logs and that unit was on our test bench before shipping!

If you happen to come up with any other issues, please let our staff know. I have sent your photos over to our testers to look out for something like this in the future!

Simon

THECNCMAN
07-23-2011, 02:08 PM
NOW I prove the machine torch and work better. I did the adapter to convert from 14mm to 17mm. my machine torch is p80 universal the longivity fitting is special 14mm

Carlos

dwdw
07-28-2011, 05:51 PM
Hi TheCNCman:
On the upper picture left side is that a sheet of white insulating material?
When I opened my 80i there wasn't any, I glued a .10 Plexiglas sheet to protect the 3 terminals on the Infineon transistor.
dwdw

KHK
07-28-2011, 09:22 PM
Glad to hear that it worked